5 no-cost ways to shrink your restaurant’s biggest electricity draw.

Your refrigerators and freezers run around the clock, making them some of your restaurant’s biggest energy users. The good news? You don’t need new equipment to start saving. These five simple tips can help cut energy costs, reduce wear and tear and extend the life of your refrigeration equipment.
If you had to guess what uses the most energy in your restaurant, you might say air conditioning or lights. But actually, it’s your coolers and freezers — they are always running. According to ENERGY STAR, refrigeration uses more electricity than any other equipment in a commercial kitchen, at a national average of almost 50%. Restaurants also use about five to seven times more energy per square foot than other commercial buildings, so that share adds up fast. That equipment runs every hour, every day, so small habits add up. Here are five no-cost or low-cost tips to help to cut its energy use—no new equipment needed.
1. Clean the condenser coils.
The condenser coil is where a refrigeration unit releases the heat it pulls out of the box. In a kitchen, that coil collects dust and airborne grease, and a coated coil forces the compressor to run longer to reach the same temperature. A field study by the Food Service Technology Center and the City of San Francisco found that cleaning condenser coils on 10 refrigeration units reduced energy use by an average of 17%, with the dirtiest units showing the biggest savings.

2. Run the dollar-bill test on your door gaskets.
Close the cooler door on a dollar bill and pull. If the bill slides out with no resistance, the seal is failing at that spot and cold air is escaping around the clock. Test several points along each door, because gaskets rarely wear evenly. A leaking door keeps the compressor running to replace air it already chilled. Gaskets also last longer when you clean them regularly. Food debris and spills can cause mold, sticking, and tears, and harsh chemicals, such as improperly diluted bleach, shorten gasket life.

3. Cover open cases overnight.
Open reach-ins and grab-and-go display cases are built to make food easy to see and easy to pick up. After closing, nobody is looking, yet the case keeps spilling cold air into an empty room all night. A night curtain fixes that. It is a pull-down or clip-on cover that holds the cold air inside the case during closed hours. Curtains are a low-cost accessory, not a no-cost habit, but the habit is what makes them work.

4. Give the equipment room to breathe.
Refrigeration works by moving heat, and it needs air to carry that heat away. A reach-in pushed tight against a wall, boxed in by stacked supplies or parked beside a hot cooking line has to run longer to move the same amount of heat. Check your manual for the manufacturer’s required clearance and keep that space open. Boxes stored on top of a unit count as a blockage if they cover the vents. The same rule applies inside the box. Shelves packed edge to edge and product stacked in front of the fans stop cold air from circulating, leaving warm spots and keeping the compressor running.

5. Cool hot food before it goes in the walk-in.
Placing a hot stockpot straight into the walk-in warms everything around it and makes the compressor run hard to bring the whole box back to temperature. Bring the heat down first with the methods your food safety plan already calls for. Divide large batches into shallow pans, set containers in an ice bath, or stir with an ice wand. These steps pull heat out of the food quickly without making your refrigeration do all the work. Food safety comes first here. The FDA Food Code requires cooked food to cool from 135°F to 70°F within two hours and to 41°F within the next four hours.

A little maintenance goes a long way.
You don’t need new equipment to start saving energy. A few minutes each week can help lower electricity costs, reduce unnecessary wear and keep your refrigeration equipment running efficiently for years to come. When it’s time for professional maintenance, TVA EnergyRight® can help you find a qualified contractor through our Preferred Partner Network. And if your HVAC system is due for replacement, check out available HVAC incentives that can help offset the cost of upgrading to more energy-efficient equipment.


